The steps to remove and replace car tire bearings are as follows:
1. Find a flat spot to park the car and release the foot brake. Place masonry in front and behind the remaining three wheels to secure the wheels, and use a jack to jack up the vehicle.
2. Remove the tire. After removing the tire, you can see the car's brake disc and brake caliper. Only after removing them can you see the front wheel bearing.
3. Use an opener to remove the dust cover outside the bearing, and you will see the large nut that fixes the bearing. Use a 30mm sleeve to remove the nut.
4. Use an 18-inch torx wrench to remove the two screws fixing the brake caliper, and slowly remove the brake caliper to prevent the brake oil pipe from breaking.
5. Remove the brake disc from the outside. If the brake disc cannot be removed, you can use two screws to tighten the brake disc holes and use the corresponding wrench to tighten the screws to remove the brake disc.
6. Use both hands to pull the bearing outward to remove the bearing.
7. Install the new bearing and replace it with a new strong nut. After tightening the nut, rivet the edge of the nut with an opening to make the nut stronger. Install the dust cover.
8. Install the brake disc and brake caliper, and the replacement is completed.
Therefore, before undertaking any removal or replacement operations, it is best to consult your vehicle manual or a professional technician for accurate guidance and advice. Also, make sure you take appropriate safety measures when doing this type of work to prevent accidents.
