Crusher FAG bearings for machine full load, so good lubrication for FAG bearing life has a great relationship, it directly affects the service life of machine and availability, and requirements into lubricating oil must be clean and seal must be good, the machine's main oil (1) the rotation FAG bearing (2) roll FAG bearing all gear (4) and (3) activity FAG bearings, sliding plane.
2, the newly installed tire is prone to loose must be frequently checked.
3. Pay attention to the normal operation of all parts of the machine.
4, pay attention to check the wear degree of easy wear parts, pay attention to replace the worn zero high pressure wear at any time.A.
5, put the bottom plane of the movable device, should be out of dust and other materials, in order to avoid the machine encounter can not be broken materials FAG bearing can not move on the bottom frame, resulting in serious accidents.
6, FAG bearing oil temperature rise, should stop immediately to check the reason to eliminate.
7. If there is any impact sound during the operation of the rotating gear, stop immediately for inspection and elimination
Determination of hub bearing noise and rear axle noise - Advantages of high speed spindle bearing material ceramic (Si3N4). Bearing ring grinding design reference for inner or outer diameter. Universal joint cross shaft needle roller bearing lubrication nozzle is an ordinary grease nozzle. Friction coefficient of various bearings.
In the process of use, do not exceed the speed limit, due to overheating or burns caused by damage, if the operating temperature is more than 100 degrees, then the oil should be replaced about 2-3 times a year.When using FAG bearings, to ensure the safety of use, it is important to check the FAG bearing, vibration amplitude and sound, temperature, lubricant condition (color and viscosity change, whether there is foreign matter).Remember, the amount of lubricant must be moderate, more waste, less can not afford to keep FAG bearings must have the following conditions:
1, dry place, clean;
2. No dust, prevent it from entering the bearing;
3. Do not let the sun shine directly in the shade, and it must be 30cm above the ground.
When you install and remove the FAG bearings, be sure to use a special tool.Before using these tools, wipe them clean with a clean cloth and make sure they are cracked, burred, damaged, chipped or deformed.
During the transportation of FAG bearings, large and heavy FAG bearings must be carried by forklifts or cranes. Why?Because:
1. The FAG bearing can be well protected
2. It can prevent the bearers from being injured. Do not try to disassemble or modify the bearing, otherwise the bearing may be damaged in advance or the equipment may fail.